172-65459MA-04 (JH7.2R-P) 14 Jul 2015
10
Disassembly / Reassembly of Components Inside the Body
Part
During Disassembly
During Reassembly
Screen
Remove by grasping the
wire ring and lifting straight
up and out
Set the screen on the screen holder and screen
holder retainer and insert as far as the snap ring
groove
Screen Holder Remove without bending
Place on the ledge inside the body, making sure
the rounded side is on top
Float
Remove, being careful not
to scratch the polished
surface
Insert, being careful not to scratch the polished
surface
Orifice Plug
Remove with a socket
wrench
Consult the table of tightening torques and
tighten to the proper torque
Orifice Plug
Gasket
Remove the gasket and clean
sealing surface
Replace with a new gasket; coat surfaces with
anti-seize
Orifice
Remove with a socket
wrench
Consult the table of tightening torques and
tighten to the proper torque
Orifice Gasket Remove the gasket and clean
sealing surface
Replace with a new gasket; coat surfaces with
anti-seize
Table of Tightening Torques
Part Name
Torque
Distance Across Flats
N
⋅
m
(lbf
∙ft)
mm
(in)
Cover Nut
180
(130)
24
(
15
/
16
)
Orifice Plug
700
(510)
46
(1
13
/
16
)
Orifice
350
(260)
38
(1½)
Cover Plug (JH7.2R-P)
100
(73)
26
(1)
Drain Plug
100
(73)
26
(1)
NOTE: - Coat all threaded portions with anti-seize.
(1 N
⋅
m
≈
10 kg
⋅
cm)
- If drawings or other special documentation were supplied for the product, any torque
given there takes precedence over values shown here.
