172-65193A-06 (G8) 8 Jul 2015
9
Disassembly / Reassembly
NEVER apply direct heat to the float. The float may explode due to
increased internal pressure, causing accidents leading to serious injury
or damage to property and equipment.
WARNING
When disassembling or removing the product, wait until the internal
pressure equals atmospheric pressure and the surface of the product
has cooled to room temperature. Disassembling or removing the
product when it is hot or under pressure may lead to discharge of fluids,
causing burns, other injuries or damage.
CAUTION
Use the following procedures to remove components. Use the same procedures in
reverse to reassemble. (Installation, inspection, maintenance, repairs, disassembly,
adjustment and valve opening/closing should be carried out only by trained
maintenance personnel.)
Disassembly / Reassembly
NOTE: Disconnected any lines that must be disconnected before disassembly can take place
(inlet piping, pressure-balancing line, condensate discharge piping, etc.).
Part
During Disassembly
During Reassembly
Drain Plug
Remove with a socket wrench
Wrap sealing tape around the threads
(3 – 3.5 times) before re-installing;
consult the table of tightening torques
and tighten to the proper torque
Strainer
Screen
Detach screen holder and
remove screen
Consult the table of tightening torques
and tighten to the proper torque
Allen Head
Bolt
Remove all 8 bolts with an
appropriate wrench
Consult the table of tightening torques
and tighten to the proper torque
Cover
Remove
Install in the same direction as before it
was removed
Cover O-ring
Remove, clean sealing surfaces
Replace with new o-ring; be sure to
coat surfaces with heat resistant grease
Float
Remove, being careful not to
scratch the polished surface
Insert, being careful not to scratch or
misshape
Discharge
Pipe
Remove
Wrap sealing tape around the threads
(3 – 3.5 times) before re-installing
Valve Seat
Holder
Remove with a wrench
Consult the table of tightening torques
and tighten to the proper torque
Valve Seat
Holder O-ring
Remove, clean sealing surfaces
Replace with a new o-ring; be sure to
coat surfaces with heat resistant grease
Snap Ring &
Washer
Remove from the valve seat
holder using needle-nose pliers
Be sure to place the washer on valve
seat before reattaching the snap ring
Valve Seat
Remove from the valve seat
holder
Clean or replace with new if sealing
surface is warped or damaged
