Our Brands:
FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries
TKH Security B.V. | +31 182 592 333 | [email protected] | tkhsecurity.com
Meridiaan 32
2801 DA, Gouda
The Netherlands
PD900/PD910/PD920
January 4, 2021
Installation ManualPD900/PD910/PD920
Page 16
5. If the long sky mounting or J-type (Candy Cane type) bracket is used, the rubber stopper is
designed to stop the ingress of condensation water inside the J-type bracket. Sudden
temperature changes may cause excessive condensation on the inner side of the J-type
tube. The below picture shows how the rubber stopper and cabling should be installed on
the tube adapter. The wider side of rubber stopper shall be at the top of cap. To seal of the
rubber stopper additional silicon-grease (O-ring grease) is essential. Apply the outdoor rated
silicone grease or sealant on the areas indicated by red dots.
Please note: security screw must be properly installed to avoid water ingress to the camera
housing. Outdoor rated silicone sealant should also be added before the screw is fitted.
The tube adapter thread is NPS 1.5” type
https://en.wikipedia.org/wiki/National_pipe_thread
) which is an straight thread in- and
ouside. Teflon tape should be used to seal the threads when attaching the tube adapter to
the bracket pipe or coupler. Refer to chapter 4 for installation guide of NPS-NPT coupler.
Note
: The accessory “Rubber stopper” is available for PD900 and PD910.
6. The cables shall be applied with electrical plumber tape to prevent shortage caused by
water.
