5 Installation
5.1 Unpacking the RGL-921
Unpack the equipment and make sure that nothing is broken before starting installation.
The RGL-921 light fixtures are not pre-adjusted in the factory and must be adjusted before taking into
operation.
5.2 Installation in the Field
1.
Connect the pre-adjusted light fixture electrically.
2.
Mount the light fixture in the breakable coupling without tightening the screws in the coupling.
3.
Turn the pylon until it is perpendicular to a line towards a point in the middle of the taxiway, 100 m away
from the RGL line.
4.
Tighten the screws in the breakable coupling to the torque shown below using a torque wrench.
14
Installation and Maintenance Instructions - LED AGL Runway Guard Lights - type 921
©
TKH Airport Solutions 2022. All rights reserved.
