TKA SP-C61T, Installation Manual

Page: 10 / 23

10
Installation
1. Remove the grill from the speaker, if applicable.
2. Connect the speaker wire to the speaker terminals:

Leave about 2' (60cm) of wire extending through the ceiling cutout.

Pull the conductors apart so the last two inches (5cm) are separated and
remove ½ " (13mm) of insulation from the end of each conductor.

Twist the strands in each conductor into tight spirals.

Attach the speaker wires to the red and black speaker terminals. Press down
on the binding posts while inserting the wire into the hole. Connect the
Positive (+) conductor to the Red terminal and the Negative (-) conductor to
the Black terminal. Make sure that no stray strands of wire are touching the
other conductor or terminal.
3. Center the speaker in the cutout. Rotate the frame as needed before tightening the
screws. Tighten the screws equally until the clamps secure the frame. Do not
overtighten.