ASSEMBLY
12.
Mount the motor Cover.
13.
Next, slide the drum onto the driveshaft, then
anchor the drum in place with the T-bolt and T-
Bolt washer. Push the drum up onto the
driveshaft while at the same time tighten the T-
Bolt by hand. Once the T-bolt is tightened as
much as possible by hand, give it a whack with
a rubber hammer.
14.
Mount each mixer paddle inside the assembled
drum with the pointed end facing downwards.
Also the V-shaped bend in the mixer should
pointed in the direction of the drum rotation
(clockwise). Use the M8 x 20 mm Hex bolt
washer and hex flange nut to secure the unit to
the lower mounting holes.
1.
Using the M8 x 70 mm long bolts, nuts &
washers attached the rear leg stand.
2.
Fit the 2 wheels to wheel axles and tighten
with hex bolt M8 x 16 bolt and washer.
3.
Using the M8 x 70 mm long bolts, nuts &
washer attached the handles.
4.
Fit the motor and gearbox assembly using
the M8 x 16 bolts, nuts & washer.
Summary of Contents for Max Mix
Page 6: ...6 PARTS BREAKDOWN...
Page 7: ...7 BOLTS BREAKDOWN...
