FITTING INSTRUCTIONS
Product:
Torq Winch 9,500lb Steel / 9,500lb Synthetic /
12,000lb Synthetic
Vehicle:
Generic
Part No.
947TJMTQ95SAA / 947TJMTQ95DAA / 947TQBK95DAA / 947TJMTQ12DAA / 947TQBK12DAA
For product warranty please refer to our website www.tjm.com.au
File: F-5969
Page 12 of 18
01/03/2021
ISOLATOR SWITCH INSTALLATION
It is recommended that an isolator switch be installed with your winch to isolate the winch to prevent
inadvertent operation of the winch. It is recommended that the isolator switch we fitted in a location where is it
easily accessible when winching. The following is a guide only, it is up to the end user to best determine the
location.
1. Disconnect the long BLACK from the negative (-) side from the vehicle battery
2. Pick a suitable position for the isolator switch in an easily accessible location &
3. Using the isolator switch bracket as a guide mark the four mounting holes where the isolator switch will be
installed
4. Remove the isolator switch bracket & drill four marked holes, making sure the drill bit will not damage
wiring or other parts when the drill bit exits
5. Deburr all holes & treat raw surfaces with rust preventative
6. Ensure the isolator
switch is to the “OFF” position
7. Using the long RED cable from the vehicles battery (+) connect it to one side of the isolator switch (it does
not matter which side of the isolator switch)
8. Connect the short red wire to solenoid box switch (+), see diagram 1 (position 3 marked on the solenoid
box)
9. Connect the other end of the short red wire to the isolator switch
10. Secure the isolator switch bracket using suitable fasteners
11. Connect the long RED cable to the positive (+) side of the vehicle battery
12. Re-connect the long BLACK from the negative (-) side from the vehicle battery
13. Check that all connections are secure &cables are not rubbing or chaffing or against any sharp edges
14. Turn the isolator
switch to the “ON” position & operate the winch in the “OUT” position. While the winch is
still operating in the out position turn the isolator
switch to the “OFF” & the winch should lose all power.
CABLE PUCK ASSEMBLY
Contents
1 x Puck
1. Push a section of rope together so that the
individual strands separate.
