FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Ford Ranger PXII, PXIII (Non-Tech pack), Everest (UA model only)
Part No.
070SB13N20A
For product warranty please refer to our website www.tjm.com.au
F-12114
Page 1 of 27
03/01/2019
Australian Standards Relating to Installing Vehicle Frontal Protection Systems (VFPS): AS 4876.1-2002
a)
Do not attach V.F.P.S. to vehicle using anchorages not intended for this purpose (e.g. engine mounting bolts), other than those
specified by the V.F.P.S. manufacturer in this instruction.
b)
Do not use this product for any vehicle make or model other than those specified by the V.F.P.S. manufacturer (as above).
c)
Do not remove any plaques or labels from the V.F.P.S.
d)
Do not modify the structure of the V.F.P.S. in any way.
•
Read instructions fully before commencing fitment.
•
Estimated Fitting Time: 4hrs
•
076SKITB20A and 946TQEXT500 supplementary kits may also be required
for vehicles fitted with a radar. (Not compatible with centrally mount radar)
•
076PSHOUSE supplementary kit may be required for vehicles fitted with 6
front parking sensors.
•
The fitment of TJM products does not nullify the OE manufacturer's
operating guidelines and/or warnings. Ensure you are familiar with and
adhere to the usage instructions specified by the manufacturer in the
owner's manual or other official documentation
.
•
Left hand and Right hand components are determined as seated in the
vehicle.
•
Check for (and remove) any build up in all captive nuts fitted to the FPS.
•
Be aware that a number of government / fleet departments require that the
tow points be painted red.
•
Ensure that the “Rated Recovery Point Label” is affixed alongside the
compliance label, in the driver’s side doorjamb.
•
When fitting accessories to TJM products (ie. driving lights and aerials),
ensure suitable washer plates are used under the mounting surface that
allow the accessory to be secured in a way that prevents it from damaging
the product.
•
When removing protective coatings, ensure all new edges are deburred,
clean any swarf from the area and apply rust preventative to exposed
surfaces.
Bolt tensions
Dia. (mm)
Nm
ft.lbs
Dia. (inch)
Nm
ft.lbs
All bolt tensions are
as follows unless
otherwise
specified.
5
5
4
1/4”
9
7
6
9
7
5/16”
22
15
8
22
16
3/8”
33
27
10
44
32
7/16”
55
43
12
77
57
1/2”
86
66