34 · www.tjep.eu
1.1. Technical information
Technical info.
RE-BAR 25 RE-BAR 40
Weight:
2.2 kg
2.3 kg
Height:
284 mm
284 mm
Width:
100 mm
100 mm
Length:
280 mm
293 mm
Wraps per tie:
2 or 3
2 or 3
Workpiece
thickness:
8 - 25 mm 12 - 40 mm
Ties per
charge:
~ 2,600
(3 wraps)
~ 2,200
(3 wraps)
Battery:
14,4V 3,0Ah Li-ion
Charging time:
Full charge = 90 min
1.1.1. Charger
Use only approved battery charger,
LI-196B1 (TJEP no. 115501).
1.2. Wire specification
Model:
TJEP galv. wire
(115151)
TJEP bright wire
(115150)
Diameter:
0.8 mm
Length:
Approx. 100 m
Material:
Galv./bright
Ties per coil
RE-BAR 25 RE-BAR 40
2 wraps
~ 220
~ 160
3 wraps
~ 160
~ 120
1.3. Applications
Tying of re-bars used for:
prefab. concrete units, floors and walls
Tying of floor heating tubes
2. Battery
2.1. Durability of the battery.
If the battery is fully charged, but the oper-
ating time significantly reduced, the battery
is defective and must be replaced.
If the battery temperature is low (10°C or
lower) the charging time will be prolonged.
Caution: Do not use defective
batteries. The RE-BAR tier will
not work properly.
4.2. Re-cycling of Li-Ion
batteries.
The batteries for the TJEP RE-
BAR tier are Li-Ion. It may be illegal to
dispose of the battery through the ordinary
waste system. Your local waste authori-
ties can inform you how to dispose of and
recycle this type of battery correctly.
When disposing of the battery, make
sure that the protection cap is placed
correctly and taped to the battery.
3. Safety features
To increase safety when tying, the RE-BAR
tier is equipped with the following safety
features.
WARNING
Before use, make sure that the
devices work as intended. Other-
wise, do not use the RE-BAR tier.
3.1. Trigger lock
The RE-BAR is equipped with a trigger
lock. Lock the trigger when the RE-BAR tier
is not in use.
When the RE-BAR tier is not in use, lock
the trigger and remove the battery. When
you start tying, insert the battery and
release the trigger lock by pushing the lock
left and upwards.
3.2. Curl guide
If you pull the trigger while the curl guide is
open, the RE-BAR tier will make a warning
signal and refuse to tie. To make the tie,
release the trigger and make sure that the
curl guide is closed.
!
!
!
Curl guide
Trigger
Trigger lock
