TJEP RC20A, Operation & Instruction Manual

Page: 130 / 136

128
wever the primary design was for flush cutting or free cutting reinforcing bars, coil rod and all-threa -
ded rod used in the construction industry.
Applications of use:
TJEP RC20A:
10 mm to 20 mm grade 60 (420MPa) re-bar (reinforcing bars), up to 13 mm inner dia-
meter pipe, 20 mm outer diameter copper water pipe, 20 mm outer diameter tubing, 13 mm conduit,
20 mm square steel tubing & bar, and up to 20 mm outer diameter all-threaded or coil rod.
TJEP RC30A:
10 mm to 30 mm grade 60 (420MPa) re-bar (reinforcing bars), up to 16 mm inner dia-
meter pipe, 30 mm outer diameter copper water pipe, 30 mm outer diameter tubing, 19 mm electrical
metallic tubing conduit, 30 mm square steel tubing & bar, up tp 30 mm water pipe schedule 40 and
schedule 80, up to 30 mm outer diameter coil rod and up to 30 mm outer all-thread rod.
Rules of Use and Storage - To use the tool to its fullest performance, the user is required to be fully
familiar with the saw itself, the cutting blades, and storage procedures upon completion of work.
Specification
The power tool is a multipurpose saw with an enclosed guard and flush cutting capabilities. The
specifications of the main unit are as follows.
Standard blade: (best for ferrous metals)
TJEP RC20A:
Supplied with (2) each 110 mm blade diameter × 1.6 mm thickness, 24 teeth. The
maximum blade RPM is 2000.
TJEP RC30A:
Supplied with (2) each 127 mm blade diameter × 1.6 mm thickness, 30 teeth. The
maximum blade RPM is 2000.
Operation
Checking and Preparation of Working Environment: Check the following before using the TJEP
RC20A/RC30A Rod Cutter. Always observe the instructions and prohibited items.
Checking of weather conditions, do not use in the rain or snow:
!DANGER: TJEP RC20A/RC30A Rod Cutter is not a waterproof power tool. If it becomes
wet, the power source system may become faulty or the operator may get an electric shock.
Therefore, when it is raining or snowing, never operate this saw outdoors, on top of buil-
dings or under roofs where rain or snow enters freely. Do not use where water accumulates or where
water splashes.
Operation Instructions
Locate the front handle in the mounting hole that provides the best grip. To operate the trigger,
depress the trigger to start the saw. Start the saw BEFORE cutting and then apply a LIGHT pressu-
re moving forward through the cut.
Do not use under high temperature and humidity or extremely cold temperature conditions. The tool
is designed for use under an allowable environmental temperature of 0 to 49°C. Operation at higher
temperature may cause the tool’s main unit to overheat. Operation at high temperature with high
humidity may cause the tool to fail due to condensation.
Also, do not operate the TJEP RC20A/RC30A Rod Cutter in very cold places or inside refrigerators
where the temperature is freezing or below.