www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
Copyright © 2020 Tivoli 05.20.20
ADNM-DTV Flicker Free TV Studio Camera Installation Instructions
7170445
Page 2 of 8
Driver Connections
Remove DTV Controller Cover: Use a small flat blade screwdriver in
the open end of the cover to release it from the base.
Connect Luminaire: Connect one luminaire linear run to
eachTerminal Connector. ADNM-DTV power supplies may have from
one to four circuits, depending on model. For example, the ADNM-
320-3-4-24-DTVC can accomodate up to 3 runs of RGBW Tivotape
when each run is 17’ in length. ADNM-60-1-5-12-DVT power supply
has one circuit. Installer is responsible for selecting the right size wire
for run length and total wattage for each circuit. Do not exceed rated
watts per circuit.
Power Supply: Connect transformer input to 120-277V AC line
voltage.
Connect DMX Controller: Connect RGB controller (DMX512 signal)
to LinearDrive 720D. Connect DMX Controller to the DMX in +, DMX -
and DMX in Shield connectors.
Replace Cover: Snap the Cover back down over the base of the
controller.
M
LINEARdrive 720D
12-28V / 24W Direct voltage controlled LED driver
TC
Group 1
Group 1 GND
Group 2
Group 2 GND
Group 3
Group 3 GND
Group 4
Group 4 GND
Ext in +
Ext in -
DMX in +
DMX in -
LedSync out +
LedSync out -
LedSync shield
D
A -
D
A +
D
A -
D
A +
To Luminaire
To Power Supply
Positive (+) Wire
To Power Supply
Negative (-) Wire
To Luminaire
Positive (+) Wire
16ga
Wire
DMX I
n +
DMX I
n -
DMX I
n Shield
To TivoCue
