www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
Copyright © 2020 Tivoli 05.20.20
ADNM-DTV Flicker-Free TV Studio Camera Installation Instructions
7170445
Page 1 of 8
Installation Instructions
Please verify the contents of the packages!
Please read instructions entirely before starting installation
Be sure power is turned off before installing or modifying the
system
Call Tivoli, LLC tech support with questions
Caution: This Power Supply is designed to work on 120-277V AC
line voltage only. Use of any other power source will cause damage,
shorten the life of the fixture and will void the warranty.
Consult any and all applicable local and national codes for
installation.
Do not conceal or extend exposed conductors through a building
wall as per local electrical code.
Warning: With any luminaire or power supply for any application,
basic safety precautions should always be followed to reduce the risk
of fire, electric shock and personal injuries. This power supply should
be installed by a certified professional.
Profile Dimensions
R
10”
10”
4”
Mounting Location Requirements
It is recommended that the enclosure be mounted with at least 10”
of open space around it for proper ventilation. Do not mount next to
or above heat radiating equipment. Operating under high ambient
temperature may increase the internal temperature and will require a
de-rating in output current. This power supply will operate efficiently
between -40° C to +80° C with adequate ventilation. The enclosure is
NEMA 3R rated for outdoor/wet applications.
Outdoor Installation
Step 1: Locate Power Supply enclosure (NEMA 3R rated) in a suitable
outdoor location.
Step 2: Orient the box in the proper orientation for outdoor use. The
solid cover must be positioned at the top to maintain water proof
integrity.
Step 3: Note the spacing of the mounting holes when determining
mounting location.
Step 4: Knock out access holes as needed. The 12” Box has knockouts
along the bottom of the box. The 16” does not include knockouts. Cut
out access holes where needed.
Caution! Be careful not to damage internal electrical components.
Step 5: Install strain reliefs (wire clamps) for ½” hole size. Input lead
wires are 18AWG. Output lead wires are 14AWG.
Input Connection:
Bring external Positive (Black) and Negative (White) Power Lines
through Strain Relief on the input side of the Transformer. Connect
to Black and White Transformer Leads using the correct size and UL
approved Wire Nuts.
Grounding: Connect the Green Ground Wire from inside the
enclosure and the Green Transformer wire to incoming ground wire.
Note: The 6” X 8” box has only one Ground Wire.
Warnings and Cautions
1. Risk of electrical shock and energy hazard. All failures should be
examined by a qualified technician. Do not open the case of the
power supply module.
2. Do not install LED power supplies in places with high ambient
temperature or close to a fire source.
