Tiviar Alpha Plus, User Manual

Page: 27 / 72

27
1.3 Installation
1.3.1 Dish Setting
After selecting Satellite, choose and insert value of Tuner Connection(Loop Through/Separate) ,
Frequency, LNB Power(On/Off), LNB Type(Single/ Universal/ Unicable), LNB Frequency, DiSEqC
Switch(1.0, 1.1) to do Dish Setting of each Satellite.
Positioner Setting menu allows support of DiSEqc 1.2 and USALS mode.
1.3.2 Satellite Search
Search Mode has options like Auto/ Manual/ Blind/ Advanced mode. Select and search.
Select Search Mode and then select and insert values of Satellite, Frequency, Symbol rate,
Polarity(Horizontal/ Vertical), Search Type(All Service/ FTA Only/ TV Only), Network Search(On/ Off), Dish
Setting, TRANSMISSION(DVB-S/ DVB-S2/ AUTO), FEC(1/2 2/3 3/4 3/5 4/5 5/6 8/9 9/10),
Modulation(QPSK/ 8PSK/ AUTO), Pilot(On/ Off) which supports search.
1.3.3 Cable Search
Auto Search - Select Search Type(All Service/ FTA Only/ TV Only) Value to easily do Cable Search.
Manual Search - Frequency, Symbol rate, QAM Mode(Auto/ QAM16/ QAM32/ QAM64/ QAM128/
QAM256), Search Type(All Service/ FTA Only/ TV Only) values can be personally chose and inserted to
enable the Search of service you want.
1.3.4 Terrestrial Search
Auto Search - Choose Search Type(All Service/ FTA Only/ TV Only), Antenna 5V(On/ Off) value to easily
enable Terrestrial Search.
Manual Search - Channel (ch5 ~ ch69), Search Type(All Service/ FTA Only/ TV Only), Antenna 5V(On/
Off)) value can be selected and inserted to Search desired channel.
1.3.5 Network Setting
Auto Search – You can easily search Terrestrial by selecting Search Type(All Service/ FTA Only/ TV Only),
Antenna 5V(On/ Off)
Manual Search – You can search the required channel by selecting or entering Channel (ch5 ~
ch69), Search Type(All Service/ FTA Only/ TV Only), Antenna 5V(On/ Off)).
1.3.6 System Recovery
System restore to factory default : Restore the factory set values in case the user has encountered
some problems after changing any new parameters of service data and other parameters which
may be in error. Press the OK button to erase all services and restore default setting.
Reset Configuration data : Maintain the service data and reset the configuration data.
Reset Service data : Maintain configuration data and reset the service data.
System restore to stored position : Restore the stored values including service data and system
parameters. Press the OK button to restore all data.
Store system data : If you want to use system parameters and service data in the future, this menu
allows you to store current state. Press the OK button to store current state.
Delete store position : Delete stored system data.
1.3.7 System Information
This menu displays general information about the hardware and software version of your receiver.