29
Problems
Blind rivet is set correctly
Blind rivet can not be inserted
Cause
Supply of compressed air is too rare
Jaws are dirty
Jaws are worn out
Jaw case and jaw case body are loose
Reduction in stroke due to lack of
sufficient oil
Oil quantity in the system too high
Wrong nose piece
Nose piece is loose
Travel-path of the mondrel is blocked
X-value is too low
Solution
(
O
) Check compressed air supply
(
O
) Set the compressed air setting on the
maintenance unit at a maximum of 7 bar
(
O
) Clean jaws
(
O
) Change jaws (see “Maintaining the riveting tool”)
(
O
) Tighten the screws/nuts (see “Maintaining the
riveting tool”)
(
O
) Check oil quantity and fill up (see “Maintaining
the riveting tool”)
(
O
) Check and adapt oil quantity (see “Maintaining
the riveting tool”)
(
O
) Change nose piece (see “Operating the riveting
tool”)
(
O
) Tighten screws/nuts (see “Maintaining the
riveting tool”)
(
O
) Empty riveting tool mandrel collector
(
O
) Reset the value of X (see “Adjusting the jaw
case body”)
Trouble shooting
