6
7
8.Installing your child car seat and securing your child for
Group III(22kg-36kg)
8.1 Removing the backrest
8.1.1 Push backrest and seat unit apart.The seat may click loudly.The
two section should come apart.Reattach the Veicro tab at the back
of the booster seat if it has come undone.The booster seat is now ready
to use . (fig.10,11)
8.2 Routing the diagonal and lap belts correctly
8.2.1 Make sure there is no twist of car belt. Route the diagonal belt on the
shoulder of your child and lap belt under the armrest of car seat on one side.
Make sure lap belt must go under armrest,diagonal belt must over the upper
armrest.
(fig.7
，
8)
8.2.2 Check and make sure there is no twist of the belt. Insert the metal
tongue of carbelt into the carseat buckle until you hear a clear “click”. (fig.6)
Warning! Make sure your child arms are above both diagonal and lap
belt. (fig.9)
10 Removing the cover
10.1 Take off the backrest cover by rasing the cover from down to up.
(fig.12)
10.2 Remove the base cover by rasing the cover from down to up.(fig.13)
9 How to use Plus FIT
9.1 Press the Plus FIT release button, push Plus FIT connection backward
to the longest position.(fig.15)
9.2 Push Plus FIT connector to the fixed point on the car till hear the crisp
voice "ka", the button turns to green, then push forward to the baby car seat
to see if it is fixed strongh enough and whether it is close to the rear seat
back of the car.(fig.16)
9.3 Shake the seat to see if it is fixed strong enough and whether the
Plus FIT connector fall off. Please follow above procedure install again.
(fig.17)
9.4 Press Plus FIT release button, the Plus FIT system can be released.
(fig.18)
12. Cleaning the cover
This child car seat must be used with seat cover as seat cover is an integral
part of child car seat. It plays an important role in ensuring that the system
works properly. Make sure that only approved replacement cover by
manufacturer could be used.
Daily cleaning and care instruction for cover
*Hand wash the cover in cold or warm water.
*Do not dehydrate. Suggest to use towel to absorb water and hang dry.
Note:
*Do not use detergent that contains chlorine bleach.
*Do not use washing machine, dehydration machine and dryer.
Hand wash Do not bleach Do not iron Do not
dehydrate
Rub gently Hang dry
ENG
ENG
11. Assembling the car seat
11.1 Take the seat out from the plastic bag and put the it flatly on floor .
11.2 Connect the elastic string on both sides of the seat base cover onto the
hook on backrest, and put the hook in the hole of seat base.Then make the
backrest from flat to upright position until you hear a clear click.
11.3 Guide the two buckle latches together engage them into the harness
buckle until you hear a clear "click".
11.4 Pull the harness adjust strap.(fig.14)
installation method: put isofix connector fix onto the car at first, then use
3-point seat belt fix baby and baby car seat.
