Page 12
For technical questions, please call 1-888-380-0318.
Item 64804 64805
Sa
FE
ty
Maint
E
nanc
E
Ba
S
ic W
E
lding
W
E
lding
t
ip
S
S
E
tup
15. Loosen the Knob on the Wire Feed
mechanism, then insert the Gun Cable
Connector through the hole on the Welder
front and into the socket on the Wire Feed.
16. Ensure that the Gun Cable Connector is fully
inserted into the socket on the Wire Feed
mechanism as shown.
no O-ring should be visible.
Tighten the Knob securely.
If Connector is not fully inserted, the gas
connection will leak, preventing shielding
gas from reaching the welding arc.
nOticE:
To prevent damage,
do not overtighten the Knob.
17. Connect the Wire Feed Control Cable to the
Wire Feed Control Socket located on the front
of the machine. Press it in until the collar snaps
into place. Note that the plug on the Cable fits
into the Socket in one specific orientation only.
To disconnect it, pull the collar back first.
iMpORtant
Securely hold onto the end of the welding wire and keep
tension on it during the following steps.
if this is not done, the welding wire will unravel and unspool
which can cause tangling and feeding problems.
18. Cut off all bent and crimped wire.
The cut end must have no burrs or
sharp edges; cut again if needed.
19. Keep tension on the wire and guide at
least 12 inches of wire into the Wire
Inlet Liner and Feed Guide.
Incorrect – Connector not fully inserted
gun cable
connector
Wire Feed
Mechanism
Knob
Correct – Connector fully inserted
Wire
Feed
control
cable
Wire
Spool
Welding
Wire
HOld WiRE
SEcuREly
Feed
guide
Wire inlet
liner
