Titanium HomeOffice PL 250, Operating Manual

Page: 28 / 64

28
− Only use one laminating pouch per lamination, as
laminating pouches may stick tightly together.
− Do not leave any laminating pouches in or next to the
laminator after lamination.
When using the laminator, a slight odour may be produced.
Ensure there is sufficient ventilation in the room, e.g. by opening windows.
Laminating
1. Move the ON/OFF switch
2
to “ON” (–).
The ready indicator will turn from dark blue to red within the next 1 ½–2 minutes.
2. Once the ready indicator
1 is red, place the document between the two sides of the
laminating pouch.
Make sure that the document is flush with and aligned as close as possible to the
sealed edge of the laminating pouch.
3. Insert the laminating pouch so that it is centred and with the closed-edge first into
the laminating pouch infeed slot
3 on the back of the laminator.
The heating rollers will automatically pull the laminating pouch in and move it to
the laminating pouch output slot
4 on the front of the laminator. Don’t use force to pull
out the laminating pouch.
4. Remove the laminating pouch and let it cool off briefly on a flat surface.
• If necessary, you can cut off excessive material after it has cooled off.
• Repeat the process if the laminating pouch has not adequately
adhered to the document.
5. Move the ON/OFF switch
2
to “OFF” (O) to switch the laminator off.
Removing a jammed laminating pouch
The laminator is equipped with an antiblocking system. If the laminating pouch was
not inserted straight or it becomes jammed in the laminator, proceed as follows:
1. Move the ABS switch
5 towards the laminating pouch infeed slot 3 and hold it down.
2. Pull the laminating pouch out of the laminator.
It is recommended you pull the laminating pouch out in the direction of its
larger end.
You can place the document in a new laminating pouch and laminate it again.
28