7
EN
DETECTOR & CLAMP
(continued)
DETECTOR LCD SCREEN OVERVIEW
1 Arrow indicator
2 Detection mode
3 Centre alignment
4 Brightness indicator
5 Battery indicator
6 Speaker indicator
1
2
4
6
5
3
POWER SUPPLY
•
The detector is powered by one 9V alkaline battery.
Battery replacement
• Remove the
battery cover door
and the batteries.
• Insert the batteries according to polarity and replace
the
battery cover door
.
MOUNTING TO THE STAFF CLAMP
• Insert the staff clamp screw into the staff clamp
mounting point.
• Rotate the staff clamp thumb screw until the clamp
is secured in place.
DETECTOR OPERATION
• Power the detector on by pressing the
power button
.
The LCD screen will turn on and the speaker will emit
a small tone to indicate the detector is operating.
• The LCD screen will display the battery level,
detection mode and speaker function.
• To change between broad, coarse and fine mode
press the
detection mode
button.
• To change the speaker volume or turn the speaker
off, press the speaker button.
• To turn on the backlight, hold down the
mode
button for approximately 3 seconds.
• Move the detector into the path of the laser beam.
• Hold the detector upright for horizontal beams (Fig. 2) or
rotate 90° for vertical beams (Fig.3).
•
The direction arrows or level line on the LCD screen
will indicate the position of the laser beam. A digital
increment display will indicate the position of the laser
beam (Fig. 2 & 3). The detector will emit a constant beep
once the level position has been located (Fig. 4).
Fig. 2
Fig. 3
Fig. 4
