11
Assembly Instructions
Once the Bungee Cord is attached to the
Rear Brace, tighten the Bolts holding the
Footboard, the Main Frame to Side Rail Bolts
as they are easier to access from the vertical
position.
Lower the Rower back to the Horizontal
position and test for proper bungee recoil.
Check Seat Rollers/Runners for dirt or debris
before sitting on the Rower Seat. Small
objects captured between the Seat Rollers
and Runners can damage the Wheels or
running surface. Check Runners for debris
prior to each use and clean regularly.
Note: The Rower Frame Bolts require periodic
checking for tightness. Do this at the end of
the first month of use and again after every
12 months
Choose a suitable location when standing the
product for storage.
Install supplied 2x AA batteries and check
monitor function. Details regarding can be
found in the Monitor section of this manual.
Choose a flat, level surface on which to use
your Rower, to avoid rocking and potential
premature wear.
Pull Bungee Cord and Hook Bungee End onto
the Bungee Hook Mount[6] as shown.
Do not cut Bungee
tie wrap before
Bungee Cord is
attached to rear
of the Rower as
shown here.
STEP 5
Completing the Rower Assembly
Tighten Frame
Bolts securely
once Rower is
standing.DO
NOT OVER
TIGHTEN.
