TSA007
A
Protective cover
B
Fingerprint sensor
C
Light
SET
OPEN
F
Battery compartment
E
SET button
Back
TSA007
A
Protective cover
B
Fingerprint sensor
C
Light
SET
OPEN
F
Battery compartment
E
SET button
Back
OVERVIEW
HOW TO USE THE FINGERPRINT SENSOR
OPENING THE LOCK WITH A FINGERPRINT
Slide the protective cover
A
to the side and place your previously read-in finger on
sensor
B
to open the lock. Please note that the lock can be opened with any finger
if no fingerprint has been stored. It is therefore important to store your
own individual fingerprint.
STORING A FINGERPRINT
1) Slide the protective cover
A
of the lock to the side.
2) Briefly press the SET button
E
on the back of the lock.
3) Place a finger onto the fingerprint sensor
B
whilst the light
C
is blue.
4) If the light
C
flashes blue, remove your finger briefly and place it back
onto the sensor.
5) Repeat the process once more.
6) If the light
C
is briefly blue and then goes out again, the fingerprint
has been stored successfully.
7) If the light
C
flashes red, it has NOT been stored successfully.
Repeat steps 2–6.
A maximum of ten fingerprints can be stored. The same fingerprint cannot
be stored several times. Please always store at least two fingerprints.
DELETING FINGERPRINTS
Press the SET button
E
for 3 seconds until the light
C
is red. All stored
fingerprints are now deleted and the lock can be opened again with
any fingerprint.
The back of
the lock is on
the inside of the front
shell of the case behind the
inner lining. Simply open the zip
fastener of the inner lining
to access the lock.
