Titan TTL650GDO, Safety And Operating Manual, Page: 20 / 27

6).Ensure that the tension pin (11) is adjusted to its far right position before assembly the
checked or the new chain and guide bar. If not, turn the tension screw (12) anticlockwise with
the slotted screwdriver. (See Fig. 21)
7). Spread the saw chain (6) around the guide bar (7). Slide the chain into the groove around
the guide bar. Pay attention to the cutting direction.
8). Align the saw chain around the drive sprocket (10) and place one corner of the guide bar
into a gap of the sprocket. (See Fig. 22)
Fig. 21
Fig. 8f
WARNING! The direction of the saw chain 'cutters' must be as indicated by the arrow
on the pruner head!
9). Make sure the tension pin (11) is inserted into the lower hole on the guide bar.
(See Fig. 23)
10).Put it together with the spring washer (4) and cover (2),and tighten locking nut (3) with the
socket wrench clockwise . (See Fig. 24a, 24b)
Fig. 22
Fig. 23
Fig. 24a Fig. 24b