OPERATION
1. Press the throttle interlock (A20), hold it in position and then press the throttle trigger (A18)
to engage the attachment (Fig. 22).
2. Release the throttle trigger (A18), this tool will be set at idle speed status.
STOPPING
1. Release the throttle trigger (A18) and let the product run at idle speed for 10-15 seconds.
2. Set the ignition switch (A19) to its off position "STOP". (See Fig. 19)
Fig. 23
WARNING!
The attachment will continue to move for some time even after the engine
has been switched off! Wait until the attachment has come to a complete stop before
placing the product on the ground!
WARNING!
Make sure that the cutting blade is not touching the ground or other
objects when starting the product!
GENERAL BEHAVIOUR
1. Check the product as well as accessories for damage before each use. Do not use the product
if it is damaged or shows wear.
2. Double check that accessories, safety guards and blades are properly fixed.
3. Always hold the product the product by its handles. Keep the handles dry to ensure safe
support.
4. Ensure that the air vents are always unobstructed and clean. Clean them if necessary with a
soft brush. Blocked air vents may lead to overheating and damage the product.
5. Switch the product off immediately if you are disturbed while working with it and when other
people enter the working area. Always let the product come to complete stop before putting it
down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate on the work and
have full control over the product.
37
25CC PETROL MULTI TOOL TTK587GDO
A18
A20
Fig. 22
Summary of Contents for TTK587GD0
Page 1: ......
