TTI885IPD
Getting
started...
Before you start
EN
21
Inserting / removing / replacing
1. Pull the sleeve (2) and insert a
suitable bit holder all the way to the
stop into the tool holder (1). Release
the sleeve (2) to lock the bit holder in
place (Fig. 1).
2. Insert a suitable driver bit into the
socket of the bit holder.
3. Remove the driver bit and insert
a new one as described above if
desired.
1
2
Fig. 1
4. 50 mm long driver bits can be inserted directly into the tool holder (1).
5. Pull the sleeve to remove the bit holder after operation.
NOTE:
Always use the bit holder with 25 mm driver bits. Do not insert
a 25 mm driver bit into the tool socket! If the bit holder is not inserted
deep enough into the tool socket, the sleeve will not return to its initial
position and the bit holder will not be secured.
Driver bits with 50mm can be inserted directly into the tool socket.
Battery pack
Attaching / releasing the battery pack
1. Lock the on/off switch (5) to avoid accidental starting by moving the forward
/ reverse rotation control (4) into the centre position (see below section
“Product functions – Forward / reverse rotation control”).
2. Align the battery pack (9) with the sliding slots of the battery docking port (9d)
and slide the battery pack in to attach it. Ensure it clicks in place (Fig. 2).
3. Press the release button (9c) and slide the battery pack (9) from the battery
docking port (9a) (Fig. 3).
MNL_18V IMPACT DRIVER_MID18-LI_IMGB_V1_211224.indd 21
2021/12/23 10:31 PM
9d
9
Fig. 2
12
9
Fig. 3
