18V COMBI DRILL Li-ion TTI270COM
TROUBLESHOOTING
1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The forward and reverse switch, which is on top of the
trigger, is positioned in the lock function.
Unlock the forward and reverse switch putting it into the
required rotation position. Push the trigger and the drill
will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the variable clutch, you can
find the variable clutch between the chuck and the drill
body. Position 1 is the lowest torque (screw driving force)
and position 20 is the highest torque (screw driving force).
The position on the drilling mark is for drill operation.
Regulate the variable clutch to a higher position to reach
the best result. Recharge battery if the drill suddenly stalls
or rotates intermittently.
3. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot, the red LED light should turn on when the
battery is charging.
4. REASONS FOR DIFFERENT CHARGING
TIMES.
Your charge time can be affected by many reasons, which
are not defects in your product. If the battery pack is only
partly discharged it may be re-charged in less than 1
hour. If the battery pack and ambient temperature are
very cold then recharging may take 1 to 1-1/2 hours. If the
battery pack is very hot it will not re-charge because the
internal temperature safety cutout will prevent it.
If the battery pack is very hot you must remove your
battery pack from the charger and allow your battery pack
to cool first to ambient temperature and then recharging
can be started. If you charge a second battery pack
immediately after the first then the charger can be
overheated. Always allow at least 15 minutes rest
between battery pack charging.