Operation
01
WARNING!
Always wear a dust mask to protect yourself against hazards resulting
1. Adjust the desired planing depth.
2.
3. Switch the product on and wait until it runs at full speed before placing it on the
workpiece.
WARNING!
Danger of kickback! Apply the product to the workpiece
only when switched on!
4.
even speed. Apply light consistent pressure against the workpiece to achieve an
even result.
5.
• Always make a trial cut before working on the actual workpiece,
especially after replacing or adjusting the planing depth.
• To achieve high-grade surfaces: work only with low feed with slight
consistent pressure on the centre of the planer base plate. Use small
depths of cut and repeat the planing process.
•
reduce planer feed, as required.
•
clogging of the chip ejector.
• Only sharp blades achieve good cutting capacity and give the
machine longer life.
19
