periodically and replace if damaged.
Keep handles dry, clean and free from
oil and grease.
15. Disconnect tools.
When not in use, before servicing and when changing
accessories such as blades, bits and cutters, disconnect tools from the power supply.
16. Remove adjusting keys and wrenches.
Form the habit of checking to see that
keys and adjusting wrenches are removed from the tool before turning it on.
17. Aboid unintentional starting.
Ensure switch is in “off” p osition when
plugging in.
18. Use outdoor extension leads.
When the tool is used outdoors, use only
extension cords intended for outdoor use and so marked.
19. Stay alert.
Watch what you are doing, use common sense and do not operate
the tool when you are tired.
20. Stay alert. Check damaged parts. Before further use of tool, it should be
carefully checked to determine that it will operate properly and perform
its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting and any other conditions
that may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorised service centre
unless otherwise indicated in this instruction manual. Have defective
switches replaced by an authorised service centre.
Do not use the tool if
the switch does not turn it on and off.
21. Warning.
The use of any accessory or attachment other than one recommended
in this instruction manual may present a risk of personal injury.
22. Have your tool repaired by a qualified person. This electric tool complies
with the relevant safety rules.
Repairs should only be carried out by qualified
persons using original spare parts, otherwise this may result in considerable
danger to the user.
ADDITIONAL SAFETY RULES FOR TILE CUTTERS
- The machine must be supplied through a residual current device (RCD) having a
rated residual operating current not exceeding 30 mA.
- Do not use diamond discs which are damaged or deformed.
- Replace table insert when worn.
- Use only diamond discs recommended by the manufacturer.
- Take care that the selection of the diamond discs is suitable for the material to be
cut.
- Wear suitable personal protective equipment when necessary, this could include
hearing protection to reduce the risk of induced hearing loss, respiratory protection
to reduce the risk of inhalation of harmful dust, wear gloves when handling
diamond discs and rough material.
- Never use blades on this machine.
- Use only diamond discs for which the maximum possible speed is not less than
TITAN TILE CUTTER 500W TTB336TCB
