Version 2.01 TS132/TS142/TS152 QIG
M
ENU
4
EXPLANATION
R
EARM OUTPUT LINE
(BLUE)-0.75 second pulse output when LOCK button is pressed
and start remote start shutdown. Used for factory alarm Re-arm. Observe that this output
comes on at the end only after all the other output have shutdown.
D
ISARM OUTPUT LINE
(GREEN/BLACK) -0.75 second pulse when and is UNLOCK
button is pressed and before remote starting. Used for factory alarm Dis-arm. This wire pulses
before any other output comes on except the parking lights.
B
LUE AND GREEN
/
BLACK AS AUXILIARY OUT
Menu 4 (Auxiliary Programming) is to program the Rearm Wire (Blue), Disarm wire (Green /
Black), GWR Wire (Orange), and Trunk wire (Red / While) for special outputs if so required.
The outputs can be used to activate sliding doors, or other auxiliary outputs.
This can be only be done if you are NOT using the normal analog ARM/DISARM wires
or if you are using a Data compatible interface module that Dis-arms and Re-arms
factory security.
The Blue Re-arm wire and the Green / Black Dis-arm wires (when programmed for M4-1
setting 1 or 2), will be activated by either pressing and holding button 3 for 2 seconds
(Activates Blue wire) or pressing and holding button 4 for 2 seconds (Activates Green / Black
wire). If programming them for sliding doors, and you need to unlock the doors first, program
it for setting 1 and there will be an unlock pulse before the Auxiliary pulse. If these wires are
programmed for setting 3, they will function as normal Re-arm and Dis-arm wires.
M4-1-1 Flash
Press and hold button 3 for 2 seconds, there will be an Unlock pulse
followed by a .75 second output pulse from the Blue Re-arm wire.
Press and hold button 4 for 2 seconds, there will be an Unlock pulse
followed by a .75 second output pulse from the Green / Black Dis-
arm wire.
