Installation
Step 4. How to assemble the left and right armrest
A
+
(DUnscrew the bolt designated as M6 on the seat frame with cross screwdriver. ®Insert the
hole on the on the armrest into the fixed bolt. ® Insert the square tube into the side piece of
the seat frame. @
B
e sure the side panel holes line up in the front and back. Thread the M6
bolt and proceed to tighten. @ Open the zipper around the shoulder air bags, pull out the air
bags, aligned the holes to the shoulders between airbags and armrest, then put the screws
inside the screw hole until fastened. Zip up at last. @put the armrest tubes connect into the
seat tubes .
B
e sure the air hose is not bent, cracked or twisted when connecting. This will prevent any
blockage.
Disassemble the armrest: Zip up and remove the screws before disassembling the shoulder
airbag. Disconnect the air tubes between the seat and armrest, unscrew the four screws on
the seat. Then lift up the front of armrest,let the square tube of armrest move out from the
plate of seat frame. Then press the button on the fixed hole which is near the back on the
inside part of the armrest. Then pull the end of armrest at same time, move the fixed hole
away from the fixed bolt which on the side of backrest.
Armrest screw hole
CD
Bolts
Shoulder screw hole
®
Button
Fixed hole
J
@
Four bolts
in the four
corners
@put the screw holes aligned
between airbags and armrest,
then put the screws inside
the screw hole until fastened.
®
seat tubes
Step 5. Connect the zipper or velcro
Put the back seat cushion, head pad onto the
backrest and connect the two parts with zipper
and velcro.
*Warm tips
Installation
W
hen selecting a pre
-
programmed massage, be sure to be still and
keep your butt pressed to the backrest as the chair will initiate a
computer body scan.
Air tap from back
connect with the
air tubes from the
back cushion
Backrest
®
Back
seat cushion
connect with
backrest b zi er
Head pad
Back seat cushion
@
Back seat cushion
connect to the two
sides of backrest
by zipper
A
Installation of back seat
.... cushion must be placed
properly centered so
that the pad will cover
the rollers properly.
Back seat cushion
connect with seat
® by zipper,meanwhile
connect the velcros
between them.
Connect the two
temperature sensing
signal line together.
Put the back seat heating
cushion bottom to connect
with the heating line under
seat frame
Connect the air tubes from
the seat with the air tap
under seat
Step 6. After the Assembly
After the assembly, please operate the
chair in this order:
O
Plug the cable line in the hole a on the
power box as shown in the right picture.
� Hole A connect with one end of cable line.
o Hole b insert plug of the remote control.
8
Insert the plug of cable line into the socket.
8
Switch on.(Switch on/off "0/1", press I down
to turn it on.)
0
Enjoy the massage by using the remote
control.
Make sure the switch is off before you
insert the plug of cable line into the
socket.
•
::I
Ill
a
o·
::I
Summary of Contents for TI-Jupiter
Page 1: ...TI Jupiter User s Manual t Please read SAFETY INSTRUCTIONS carefully before using the chair...
Page 5: ......
Page 6: ......
Page 9: ......