Precautions for Use
Names of Parts
Specifications
Directions for Use
DANGER
CAUTION
CAUTION
DANGER
WARNING
5A
Operating temperature
Operating voltage
DC12V ~ 20V
Approx. 5 Gallons
Approx.
10
ft
Delivery volume
Suction pipe length
Discharge hose length
Applicable liquids
Fuse
+5˚C ~ 40˚C (41˚F ~ 104˚F)
Diesel, DEF(AdBlue), Water, Kerosene, Antifreeze, Windshield washer fluid,
Mild detergents, Agricultural chemicals, Light oils.
Toggle Switch
Nozzle holder
Nozzle
Drum bung adapter
Suction pipe
Discharge hose
Operating lamp(LED)
Follow all directions below to prevent
serious injury.
Do not use for flammable liquids or
concentrated acids.
Be cautious. This pump does not
have an explosion proof motor.
Do not use near the flammable
materials such as gasoline, gas, etc.
Only use on applicable liquids
written on the specifications.
These instructions are to ensure the product is used correctly, safely, and to prevent any possible risk or damage to the user
and/or others people. Our company shall not take any responsibility for any failure of product, malfunction and damages
caused by improper use by the user or third parties.
Make sure the pump is tightly
secured to the drum(tank) before
turning the pump on.
Do not refuel directly while the
vehicle or equipment is turned on.
Do not leave the pump unattended.
Do not bend, bind or pull the power
cord by force.
Make sure to use the pump on even
surface.
Do not allow children to operate the
product without adult supervision.
After using the pump, do not keep it
on its side or upside down.
Make sure to remove any left-over
liquid in the discharge hose after
each use.
Do not alter or disassemble the
pump.
Do not run the pump ‘dry’ or let the
pump idle without transferring.
Make sure to turn off the power after
using the pump.
Do not shock the pump.
Do not use deteriorated or
contaminated liquids and fuels.
Do not place the pump in a wet area.
Do not use this pump for hot liquids
above 40°C (104°F ).
WARNING
2
3
3
6
4
2
5
8
11
1
7
10
Insert the suction pipe into the
drum
.
Tighten the drum bung adapter.
Pull out the nozzle from the
nozzle holder.
Place the nozzle into the receiving
container to transfer liquid.
Toggle switch ON(Up).
Pull the nozzle lever and start
supplying the liquid.
Release the lever when the liquid
supply is completed.
Toggle switch OFF(Down).
Pulling the lever of the nozzle,
lift it up.
Let the left-over liquid in the hose
flow back into the drum (tank).
Insert the nozzle in the nozzle holder
for storage.
Approx. 850 ~ 33.5”~ 34”
9
Follow all directions below to prevent
serious injury.
Follow all directions below to prevent
serious injury.
