TA750
(0001)
58
/
98
Fault
Cause
Remedy
Plastic straps not sealed
properly, the seal is not OK. The
upper strap is not cut completely
or it is irregular.
Welding time too short.
Check value set on the operator
panel and correct, if required.
Welding plate bottom
(9)
and/or
welding plate
(33)
were polluted,
gearing is worn or defective.
Clean welding plate bottom
(9)
and/or welding plate
(33)
, check
gearing, replace when damage
becomes visible.
Cutter
(22)
is worn or defective.
Check cutter
(22)
for damage and
replace it if required.
Welding motor
(503)
and/or
circuit board
(120)
defective or
loosen cable connections.
Visual check for loosen cable
connection, re-establish the cable
connection if required. Contact
TITAN-Service.
Li-Ion battery defective or
insufficiently charged.
Check charge of Li-Ion battery and
recharge or, if required, replace it.
Use of inappropriate plastic
strap.
Use appropriate plastic strap, ask
your TITAN
– Adviser for advice.
During welding both straps are
cut.
Welding time too long and/or
strap tension too strong.
Check value set on the operator
panel and correct, if required.
Welding plate bottom
(9)
and/or
welding plate
(33)
were polluted,
gearing is worn or defective.
Clean welding plate bottom
(9)
and/or welding plate
(33)
, check
gearing, replace when damage
becomes visible.
Following the welding cycle the
tool cannot be detached from
the strap, lever 3
(62)
must be
actuated with enormous force
being applied.
De-tension unit is not released /
de-blocked.
Slightly pull lever 3
(62)
(do not pull
it completely) and check whether
the non-return unit is de-blocked.
Contact TITAN-Service.
De-tension unit is blocked by
something or it is damaged.
Check if foreign objects are found in
the de-tension unit or if visible
damage can be detected. Contact
TITAN-Service.
Gear
(90)
is damaged.
Check if the gear
(90)
and the feed
wheel
(91)
can be turned easily and
evenly. Contact TITAN
– Service.
H TA750 EU 46/17
Summary of Contents for TA750
Page 31: ...TA750 0001 31 98 12 Konformitätserklärung H TA750 EU 46 17 ...
Page 59: ...TA750 0001 59 98 12 Declaration of conformity of the machine H TA750 EU 46 17 ...
Page 88: ...TA750 0001 88 98 12 Déclaration CE de conformité des machines H TA750 EU 46 17 ...