The speed increases as you turn the switch
towards the higher number and decreases on the
lower number. (See Fig 5)
6. USING THE KEY CHUCK
The hammer comes supplied with a 1.5-13mm
chuck, which is used for smaller drill bits. After
deciding if hammer or normal drilling is required
proceed with following instructions. Inserting
a drill bit into chuck. Before installing drill bit,
remove mains plug from mains supply.
Place chuck key into chuck, turn key anti-clockwise
to undo/loosen chuck insert drill/tool and firmly
tighten chuck by turning key clockwise. Remove
key and put in Blow Mould Case.(See Fig 6)
7.HAMMER DRILL FUNCTION
1. Adjust the dial selector to position“ “ to
provide rotation of the chuck (see Fig7)
2. Adjust the lever selector to position“ “ to
provide the hammer action (see Fig8)
3. You are now set up for hammer drilling into
masonry.
8.DRILLING FUNCTION
1. Adjust the dial selector to position “ “ to
provide rotation of the chuck (see Fig9)
2. Adjust the lever selector to position “ “ to stop
the hammer action (see Fig10)
3. You are now set up for drilling function.
WARNING!
Only use 13mm key chuck for drilling
function mode, never use to hammer
action.
9.HAMMER FUNCTION
1. Adjust the dial selector to position “ “ to stop
rotation of the chuck (see Fig11)
2. Adjust the lever selector to position “
“ to
provide the hammer action (see Fig12)
3. You are now set up for chisel work using
hammer action.
WARNING!
If the hammer/drill dial selector will not
drop into place slightly rotate the chuck
to re align the gear box.Before operating select
required mode by aligning symbol on the dial
Fig 8
Fig 9
Fig 6
Fig 7
Lock Button
loosen the chuck
