English
6
Material
Container
Setup
Start
1. make sure the battery pack is
removed. Remove the material
container from the pump
housing by turning the pump
housing ring counterclockwise.
Remove the suction tube.
2. Fill the container with the
material to be used.
4. Insert the suction tube into
the intake opening.
Note: Make sure the suction tube
is inserted as far as it will go to
ensure a tight fit.
5. Line up the tab (c) on the
pump housing with the notch
(d) on the material container.
6. Twist the pump housing ring
to thread the container onto
the pump housing.
3. Place a few drops of
household oil down the intake
(a) and return openings (b) in
the pump housing.
Material Preparation
It is important to mix the material thoroughly
before you begin. Do not shake the material
to mix it. Always stir the material gently but
thoroughly before use.
Remove any skin that has formed on the top
of the material. Do not mix the skin into the
material. The skin can break up and clog the
sprayer. Older paint may need to be strained.
Note: If you are spraying up, point
the suction set opening toward the
back of the container (a). If you are
spraying down, point the suction
set opening toward the front of the
container (b)
4
2
(c)
(d)
5
(a)
(b)
3
6
(a)
(b)
1
