17. Reassemble the foot valve assembly into the pump block.
18. For High Rider cart units, thread the siphon tube into the foot
valve and tighten securely. Make sure to wrap the threads on
the siphon tube with Teflon tape before assembly. Replace
the return hose into the hose clip on the siphon tube.
19. For Skid and Low Rider units, insert the elbow on the
siphon assembly into the bottom of the foot valve housing.
Push the retaining clip up into the groove inside the foot
valve housing to secure the siphon assembly in position.
Thread the return hose into the pump block and tighten
securely.
20. Place the front cover on the pump housing and secure in
position using the four front cover screws.
21. Turn on the sprayer by following the procedure in the
“Operation” section of this manual and check for leaks.
Replacing the Filters
Pump Filter
1. Loosen and remove the filter housing by hand.
2. Slip the filter off of the filter support spring.
3. Inspect the filter. Based on inspection, clean or replace
the filter.
4. Inspect the seal. Based on inspection, clean or replace
the seal.
5. Slide the new or cleaned filter over the filter support spring
with the adapter in place. Push the filter into the center of
the pump block.
6. Slide the filter housing over the filter and thread it into the
pump block until secure.
Pump
Block
Filter
Spring
Filter Housing
Seal
Filter Support
Spring
Filter
Adapter
NOTE: The filter housing should be hand-tightened,
but make sure the filter housing is seated fully
into the pump block.
NOTE: Repacking kit P/N 704-586 is available. For
best results use all parts supplied in this kit.
Gun Filter
1. Move the gun trigger lock to the unlocked position.
2. Loosen and remove the handle from the gun body.
3. Turning clockwise, unscrew the filter from the gun body.
4. Turning counterclockwise, screw the new or cleaned filter
into the gun body.
5. Make sure the handle seal is in position and thread the
handle into the gun body until secure.
6. Move the gun trigger lock to the locked position.
NOTE: For more detail, part number information, and
complete assembly drawings, please see the
LX-80
II
Professional Airless Gun Owner's
Manual (P/N 313-2293).
Handle
Handle
Seal
Filter
Gun
Body
NOTE: Left-handed threads require turning the filter
clockwise to remove.
© Titan Tool Inc. All rights reserved.
13
