7
SAFETY INSTRUCTIONS
The following safety rules should be followed to avoid serious injury or property damage.
NOTE
Always remove the plug from the electrical
outlet before servicing this pump.
1.
Check with your local electrical and plumbing codes to ensure you comply with the regulations. These codes were
designed with your safety in mind – be sure to understand and follow the rules. Canature does not guarantee or represent
that the product complies with specific local codes.
2.
Canature recommends that a separate circuit be led from the home electrical distribution panel and properly protected
with a circuit breaker. Canature also recommends that a ground fault circuit interrupter (GFI) be used.
Consult a licensed electrician for all wiring.
3.
Do not stand in water when connecting or disconnecting the power cord from the outlet.
4.
This product should be connected to a three-prong grounded outlet equipped with a ground fault circuit interrupter.
5.
Do NOT pump flammable liquids with this pump as an explosion or fire could result.
6.
Do NOT run this pump dry. Running this pump without water will damage the mechanical seal, reduce the life of
the pump, and void the warranty.
7.
Do NOT touch metal motor housing for at least 30 minutes after pump has operated. A severe burn will result if
pump is NOT allowed to cool.
8.
Do NOT lift the pump by the electrical cord.
9.
This product does NOT require lubrication. A special oil has been put into the motor housing at the factory for
lifetime lubrication of the bearings. Use of any other oil can cause damage and void the warranty.
