Titan DURO PROFESSIONAL Series, Operating & Installation Instructions Manual

Page: 12 / 16

12
NOTE
Do NOT remove the impeller
from its shaft.
Item # Description
1
302701 Pump Volute (8097)
302728 Pump Volute (8098)
2 302702 Rubber Gasket
3
302703 Impeller (8097-78.4 MM)
302704 Impeller (8098-76.2 MM)
4 Pump Bracket
5 302705 Screw
6 302706 Mechanical Seal
7 Stator
8 302707 Lip Seal
9 Bearing
10 Rotor & Shaft
11 Pump Gasket
12 Bearing Housing
13 302708 Lock Nut
14 302709 Washer
15 302710 Rubber Seal
16 Top Cover
17 Screw
18 Grommet
19 Cord Screw
20 Power Cord
21 Capacitor
22 Handle
23 Oil Plug
CLEANING THE PUMP
1.
Always disconnect unit from power supply before any servicing is performed.
2.
Disconnect discharge piping and remove pump from sump basin.
3.
Submerse pump in a disinfectant solution (Clorox or chlorine) for at least one hour before disassembling pump.
4.
Unscrew the seven (7) stainless screws and gently pry volute from seal plate using a screwdriver.
5.
Use a flathead screwdriver to hold the shaft.
6. Turn the impeller counter-clockwise to release the impeller.
7. Remove debris from around the shaft and on or under the impeller.
8. Reattach volute and reassemble.
DO NOT remove countersunk screws holding seal plate to stator housing or warranty will be void.