TTB1300PRW by TITAN
Remove any dirt deposits from the nozzle (17/18) hole using the cleaning needle (20)
(Fig. 28).
4. Check for worn or damaged parts. Replace worn parts as necessary or
contact an authorised service centre for repair before using the product again.
A cleaning needle (20) is supplied with this product and stored on the back
page of instruction manual.
The golden rules for care
WARNING!
Always switch the product off, disconnect it from power
supply and let the product cool down before performing inspection,
maintenance and cleaning work!
1. Keep the product clean. Remove debris from it after each use and before
storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life
of the product.
3. Inspect the product before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts.
WARNING!
Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualified
specialist!
General cleaning
1. Clean the product with a dry cloth. Use a brush for areas that are hard to
reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE:
Always keep a reasonable distance between the nozzle and
the object to be washed in order to avoid damage.
General operation
Nozzle
Care and maintenance
TTB1300PRW by TITAN
EN
In
more
detail...
30
95813_IM_TTB1300.indd 30
95813_IM_TTB1300.indd 30
2020/9/23 上午9:23
2020/9/23 上午9:23
