Titan 5052931645213, Manual

Page: 20 / 36

TTB703SSW by TITAN
Before you start
Getting
started...
GB
IE
20
NOTE:
To prevent personal injury, always turn saw OFF and
disconnect the plug from the power source before changing
blades.
NOTE:
The saw blade can be suspended straight (37) or
transverse (38).
This saw uses pin-end scroll saw blades.
> Turn off and unplug the saw from the power source.
> Slide the blade guard all the way up.
> Release the blade tension by lifting up the blade tension lever [23].
> Push down on the upper blade holder [2] to remove the blade from the holder.
Remove the blade from the lower blade holder [6].
> To install the blade, hook the blade in the recess of the lower blade holder [6].
> Push down the upper blade holder [2] to insert the blade into the slot of the
upper blade holder.
> Push down the blade tension lever [23] and adjust. Make sure the blade
is properly located in the blade holders. Make sure proper tension is applied on
blade. If the blade tension is too tight or too loose, lift up the blade tension lever
[23], adjust the tension setting by rotating it. Clockwise will increase the blade
tension, counterclockwise will decrease the blade tension. Adjust 1-2 turns, then
push down the lever to reach desired blade tension.
> Lower the blade guard to its original position.
Blade removal and installation
WARNING: Blade teeth are sharp. Be careful when handling the
blade.
WARNING: Make sure the blade with the teeth to the front of the
saw and pointing downward.
WARNING: Product damage! The two suspensions (37 and 37
or 38 and 38) of the saw blade must be identical. The saw blade
can become damaged if rotates.