HPE
H 224 EU 21/06
h
g
7. Adjustments
7.1. Cutter adjustment
The cutter has to be adjusted for the respective thickness in the case of varying
strap thickness.
Loosen locking screw
(g)
. Turn stop screw
(set screw with flat point)
(h)
by means of
a Socket spanner in a clockwise direction
= less cutting depth; counter-clockwise =
greater cutting depth. Fasten locking
screw
(g)
after adjustment has been
completed.
After adjusting there should not be any, or very few, signs of cutting
on the lower strap.
7.2. Distance between the feed wheel and the gripper plate
The distance between the feed wheel (
d
)
and the gripper plate
(e)
is adjusted to
0.2
mm
. The adjusting screw
(i)
is located
behind the plastic cover of the housing.
Unscrew the lock nut
(k)
using the 10 mm
open-jawed spanner and adjust a
0.2 mm
gap at the adjusting screw
(i)
. Fasten lock
nut after adjustment has been completed
and fix plastic cover.
The feed wheel and the gripper plate may not come into contact
with each other, otherwise both parts will be subject to premature
wear.
k
i
