Titan Lifts HD2P-13KCL, Installation, Operation & Maintenance Manual

Page: 15 / 40

11
WARNING: DO NOT PERFORM ANY MAINTENANCE OR INSTALLATION
OF ANY COMPONENTS WITHOUT FIRST ENSURING THAT ELECTRICAL POWER
HAS BEEN DISCONNECTED AT THE SOURCE OR PANEL AND CANNOT BE RE-
ENERGIZED UNTIL ALL MAINTENANCE AND/OR INSTALLATION PROCEDURES
ARE COMPLETED.
DANGER: DO NOT RUN POWER UNIT WITHOUT FLUID. DAMAGE TO PUMP
CAN OCCUR. THE POWER UNIT MUST BE KEPT DRY. DAMAGE TO POWER UNIT
CAUSED BY WATER OR OTHER LIQUIDS SUCH AS DETERGENTS, ACID ETC., IS
NOT COVERED UNDER WARRANTY.
WARNING: The wiring must comply with local code. Have a certified licensed
electrician make the electrical hook-up to the power unit. Protect each circuit with time delay
fuse or circuit breaker 208v.230v single Phase. 60Hz 30 Amp.
18) Press and hold power button on motor to operate lift. Raise carriages all the way to the
top of the lift, then lower carriages down to the ground to bleed air from the hydraulic
system prior to adjusting cable tension. NOTE: Cables must be adjusted so that the
safety locks engage simultaneously prior to lifting any weight. In order to adjust the
cables properly, you will need to raise the lift to determine which side is engaging into
the lock latches first. Whichever side is higher, tighten the nut on the cable end pointing
upward in the carriage to raise the other side that is trailing behind. When the lift is
properly adjusted, the locks will engage together and you will hear only one click.
19) Once all adjustments are finished, you can install the lock covers on each side of the
column using the (8) supplied cap head bolts and washers. Also, don’t forget to install
the Truck Adapter mounting brackets on each column as well as installing the black “toe
guards” onto each arm, while you are finishing up.