Installation Example
• Plug the controller into a standard 120V wall outlet. A 120V power supply is required. This
controller is water resistant, however it is not water-proof, so do not install it anywhere it
will come in contact with water.
• Ensure that the device being connected to the controller has the proper voltage and will not
exceed the maximum amperage rating.
• Connect the device to the controller using the outlet on the front.
Troubleshooting Tips
1. Is the photocell working?
During the daytime the green LED on the top right edge of the
controller labeled Daytime will illuminate. During the night this LED will be off. The LED
has a 30 second delay when switching between Day and Night.
2. Can I connect more than one device to the controller?
Yes, as long as the total
amperage of the devices does not exceed the maximum amperage rating of the
controller. It is recommended to keep the total amps at or below 80% of the total rating.
3. The humidity does not seem to be correct...
The sensor on the controller is located on
the bottom of the unit in the protective plastic “cage.” Make sure the unit is not being
affected by other factors such as direct sunlight exposure or areas that may not have
good air movement.
4. The controller isn’t powering on...
Ensure that the controller is fully inserted into the
power outlet. Test the controller using a power outlet that is confirmed to be working.
If it still does not power on and the LEDs do not illuminate, contact the Titan Controls
®
technical service representative at 1-888-808-4826.
Safety Notes
1. These safety and operating instructions must be kept in a safe place for future reference.
2. All warnings on this product and in these instructions must be observed closely.
3. All operating instructions must be followed.
4. If the instructions as provided by the manufacturer are not followed, damage to the
product may result and warranty may be voided.
5. Install your controller at least 8 ft. away from any devices that produce large amounts of
electronic noise, such as electronic ballasts or ozone generators.
6. Do not use this controller near water.
For example:
near a bathtub, washbowl, kitchen
sink, or laundry tub, in a wet basement, or near a swimming pool, etc.
7. Do not install the enclosure near any heat source.
8. Do not block any ventilation openings. This product is a Safety Class 1 Controller. The
main plug should be inserted in a power socket outlet only if provided with a protective
earth contact.
Controller Specifications
Input Voltage: 120VAC
Maximum Amperage: 14.5 Amps@ 120V AC
Humidity Control Range: 20% - 90% rH
Separate Day & Night Settings: Controlled by photocell
Humidity Accuracy: +/- 5% rH
Humidity Dead-band: 5% rH
4
5
Eos
®
2
Eos
®
2
Eos
®
2
Eos
®
2
Eos
®
2
Eos
®
2
Eos
®
2
Eos
®
2
Eos
®
2
Controlling a Humidifier
Controlling a Fan
Controlling a Dehumidifier