Titan Attachments 191539, Operator'S Manual

Page: 13 / 34

13
SECTION 2: DAILY INSPECTION
ATTACHMENT MOUNT FRAME
Inspect the Bob-Tach wedge mounts (item1), mounting flange (item2) and all welds on the
attachment mount for wear or damage each time the attachment is removed from the loader.
Refer to
Figure 2-1.
Figure 2-1
MOWER INSPECTION
Check the following items every 25 hours of operation:
• Check blade for cracks or damage. Replace if necessary.
•
Check blade mounting hardware for proper torque 350N.m (260 ft-lb).
• Check deck and shield. Repair if damaged or replace if necessary.
•
Check for damaged or missing decals. Replace if necessary.
• Check for damaged or leaking hydraulic hoses or fittings. Replace if necessary.
•
Clean debris, leaves, grass and flammable material from deck area and pulley covers.
• Lubricate all 7 grease points.
•
Check blade belts for condition and wear. Adjust or replace as necessary.
• Check for loose, damaged, or missing nuts and bolts. Retighten or replace if necessary.
WARNING
AVOID INJURY OR DEATH
Never work on a machine with the attachment raised unless secured by an approved
support device. Failure to use an approved support device can cause the lift arms, boom,
or attachment to fall and cause serious injury or death. Diesel fuel or hydraulic fluid
under pressure can penetrate skin or eyes, causing serious injury or death.
Fluid leaks under pressure may not be visible. Use a piece of carboard or wood to find
leaks. Do not use your bare hand. Wear safety goggles. If fluid enters skin or eyes, get
immediate medical attention from a physician familiar with this injury.