TIPTEL 332 SD, Operating Instructions Manual

Page: 13 / 48

Outgoing messages (OGMs)
13
Memory cards
Notes
Your tiptel 332 SD supports all standard SD (Secure Digital) and MMC (Multi Media
Card) memory cards with a capacity between 32 MB and 2 GB. SDHC cards are ac-
cepted but are going to be formatted to 2 GB. Memory cards are available from a
huge number of suppliers with different qualities so that we cannot recommend the
use of any particular card.
Memory cards are not free from wear. They have a limitation in writing cycles. In case
your answering machine reports a memory card error or you experience interruptions
in your recordings you should use a memory card from another manufacturer or a
new one.
The memory use is some 2 minutes per MByte which results in some 17 hours re-
cording capacity with a 512 MByte memory card.
After insertion of a new memory card a new folder with the name "TIPTEL" will be cre-
ated. To this folder the answering machine will save up to 999 recordings.
The memory card has to be formatted with the file system FAT16. In case you get an
error message upon inserting the card you can also format it in your answering ma-
chine. Please note that all data on the card will be deleted then.
Any standard card reader plugged into your computer's USB port can read the mem-
ory card so that you can archive or play back the recordings on your computer. Re-
cordings that have been edited or renamed by your computer can no longer be
played back with your tiptel 332 SD.
Remove the memory card only with your answering machine in stand by mode.
Do not remove the card during recording or play back.
Firmware update
In case you wish to perform a firmware update you will first have to download the
firmware from our homepage to your computer. Then save this file to the memory
card's folder with the name "TIPTEL". Now insert the memory card again into your an-
swering machine. If your tiptel 332 SD detects a new firmware, firmware update will
start automatically. Press and hold down the STOP key for 2 seconds to have the
firmware version shown in the LCD.