9
E
N
G
L
I
S
H
STEP 1: Prepare the marker for disassembly.
To do so, first follow the unloading and air supply removal
instructions on page 14 and never disassemble a marker that
is under pressure.
STEP 2: Remove Battery Clip/old battery (from marker).
1) Remove left grip (2 bolts).
2) Carefully work battery out of receiver cutout bringing non-
connected end out first. As you remove battery from receiver,
do not rip wires off of internal components.
3) Carefully remove old battery from battery clip connector.
E-TRIGGER
TM
Battery Installation or Replacement
Before installing air supply, install 9 volt battery (not included).
E-TRIGGER
TM
Tuning and Operating Instructions (continued on page 10)
STEP 3: Install new battery.
1) Attach 9v battery to battery connector and
be sure wires lay flat inside the cutout area of
receiver (as shown on page 11).
2) Carefully tilt and insert your new battery, wire
attached end first, into receiver as shown.
3) Reinstall left receiver grip with 2 grip bolts.
TURNING ON = The E-TRIGGER
TM
automatically turns on
when you pull the trigger.
TURNING OFF = The E-TRIGGER
TM
automatically turns off
after 10 minutes or so of inactivity.
E-TRIGGER
TM
Tuning and Operating Instructions
Familiarize yourself with and follow these instructions to select
the firing mode of your choice from the Firing Mode Setting -
Firing Response Description options on page 10.
Selecting Firing Mode
Mode Adjustment - Top Access Opening
• With screwdriver, turn the Mode Adjustment switch
to select desired firing mode setting on page 10.
Selecting Rate of Fire
Rate Adjustment - Lower Access Opening
• Turn the Rate of Fire
Switch clockwise
to increase the
rate of fire.
• Turn the Rate
of Fire Switch
counterclockwise
to slow the rate of fire.
Battery installation is complete.
