Copyright © 2011
Seite: 15
Motz-Computer
Service und Vertriebs GmbH
Pfennigbreite 20 – 22
D-37671 Höxter
Germany
Programming fanciers data from PC
If you want to program a new allocation table into the MC1100 clock please program first the fanciers
data or if already done, please select the fancier in the configuration window. For communication
please refer to chapter pc communication.
Deleting fancier
To delete fanciers data please select the fancier in the configuration window and press the „0“ key.
Afterwards you have to put in the pin code of this fancier (It’s the same he uses for deleting race
data).
7. MC1100 master functions
In the following will give a detailed description of all available functions and in which mode it can be
operated.
Basketing
Only available in CLUB mode.
This chapter describes how you get your pigeons registered with the basketing unit. During the
basketing procedure the internal clock of your MC 1100 is automatically adjusted by the basketing
unit. The time signal is sent from the satellites of the global positioning system (GPS) which works in
every area of the world.
Use the basketing unit for basketing !
Make sure that the (GPS) time receiver is connected to the master unit.
Connect your MC 1100 to the master unit.
If no signal is responded from the time receiver the red light at the basketing unit will switch on. In
that case please turn off the basketing unit for a few seconds and power up again without a MC1100
clock connected.
In case of time receiver problems the red light will switch on
If there is a GPS time receiver connected the number of satellites are indicated through the flashing of
the green light. The number of short flashes after a longer switched off period shows the received
