2
IP Power Socket 5G10A v2 – LANLIS-002
www.tinycontrol.eu
Notes on the safe use
It is essential to read the entire contents of the operating instructions and adhere to its
recommendations. The manufacturer is not responsible for the consequences of not ap-
plying the recommendations of this manual and use the power socket inconsistent with
its intended purpose. The product should be kept away from children.
Do not connect a power strip to the sockets without the correct installation
against electric shock (without contact (pin) protective!)
Prior to using a power strip:
• Before using a power strip, check its technical condition - it is prohibited to use a power
strip in which any part is damaged -
PRESENT DANGER OF ELECTRIC SHOCK / OF FIRE
.
• Before connecting the device / devices into a power strip, make sure the maximum total
current consumption in watts (W) equipment / devices that want to simultaneously con-
nect to a power strip. The total power of the connected device / devices to be connected
should not exceed that specified for the power strip.
• Power strip technical data - including above all permissible current rating and maximum
permissible load located on the housing. Technical data can also be seen on the packa-
ging or in the data sheet (available at: www.ledats.pl, www.tinycontrol.eu or www.wire-
lesslan.pl).
• Before connecting the power strip to the mains or before connecting to a power strip,
make sure the connected device is turned off.
• Before starting work, the power cord should be fully developed.
Replacing the fuse link:
1. Remove the power strip from the mains.
2. Remove cap of fuse housing and remove the faulty cartridge fuse.
3. Install a new cartridge fuse type:
5x20 mm WTA 10A 250V
.
4. Screw cap with insert into the socket.
5. Connect the power strip to the mains.
NOTE: defective fuse CAN NOT BE REPAIRED. Replace it with a an efficient.
Restrictions:
• It is forbidden to have any independent disassemble, modify, adapt or repair a power
strip or its components, in case repairs are necessary - please contact an authorized
service center.
• It is forbidden to remove and / or bridging and / or any interference with any components
of power strip, including primarily switches, earthing pins, thermal protection, overload
protection.
NOTE: To reduce the risk of electric shock or fire, do not remove the cover. Service
work can only be carried out by qualified personnel. Repairs have a qualified service
personnel using only original parts. Only this guarantees that the safety equipment
is maintained.
