ee--m
maaiill::
vvooiiccee::
360.854.9559
ffaaxx::
866.783.1742
12
WRC-4 Web Based Remote Control
INSTALLATION
E-Mail Setup Dialog
The E-mail Setup dialog specifies settings
necessary to send e-mail alerts from the
WRC-4 using the SMTP protocol.
The email setup information needed below
is best obtained from the IT department, but
if that's not possible, try this. Open an
email message and select View, then
options on the selected email. The Internet
header information is displayed, which
shows all the information about the local
mail server. Remember that with the cur-
rent WRC-4, the mail server acts as a client.
This means there has to be either a valid account that the email is validated against or email forwarding is left
enabled. In most mail servers this feature is disabled to prevent being misused as a Spam server.
SMTP Server Address
IP address of the e-mail server.
SMPT Port
TCP port on the e-mail server (usually 25).
Return Address
Return e-mail address for alerts sent from the WRC-4
(Don't forget to put the (less then, greater then) "<" and ">" characters around the address).
Host ID
For most e-mail servers, this can be any string.
Recipient Addresses
E-mail addresses (four) of alert recipients
(Don't forget to put the (less then, greater then) "<" and ">" characters around each address).
Save/Test
Saves the settings and sends test e-mails to each recipient.
OK
Saves the settings and exits.
Cancel
Exits without saving settings.
About Dialog
The “About” dialog displays the firmware version numbers; Broadcast
Tools® contact information, Web link, and e-mail link.