Tineco iCARPET Series, Instruction Manual

Page: 15 / 40

EN
13
MAINTENANCE
Note:
• For optimal performance and to prevent odors,
always
clean
and
dry
DWT, filters, brush roller,
brush roller cover, 2 in 1 nozzle completely
after each use.
• Please make sure each part is installed correctly
or the appliance may not work properly.
• After maintenance, place the appliance
vertically. Do not expose the appliance to direct
sunlight, and store it indoors in a dry place.
Main Body
1.To reduce the risk of injury, switch off before
performing maintenance.
Fig.D-1
2.Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Fig.D-2
Dirty Water Tank
1.When dirty water reaches the Max line, the
appliance will stop working and show a
reminder on the display.
2.Step on the recline pedal and press the DWT
handle to remove it.
3.Pull up the tank lid and mesh filter to empty
the DWT. Use the cleaning tool to remove
remaining debris. Rinse the inside of the DWT
& tank lid & floater & mesh filter and place back
into the appliance.
Fig.D-3
Note:
• Check if the floater is in good condition and
press it to the bottom.
Sponge Filter
1.Remove the DWT, take the filter out and wash
it after each use.
Fig.D-4
2.Reinstall.
Fig.D-5
* A spare sponge filter is provided for your
replacement.
Brush Roller Cover
1.Press brush roller cover release button on the
cover and pull upward to remove.
Fig.D-6
2.Rinse with water. Use the provided cover
scraper to clean the gap in the front side to
avoid blockages.
Fig.D-7
3.When replacing, always latch the brush cover
into place to avoid leakage.
Fig.D-8
Brush Roller
1.Remove the brush roller by squeeze the brush
roller tab and pulling out.
Fig.D-9
2.Using the cleaning tool, remove the hair and
debris wrapped around the roller and rinse
with water. Allow it to dry completely before
reinstalling.
Fig.D-10
3.Remove hair and debris from the brush roller
chamber and the opening with a tissue or a
damp cloth.
Fig.D-11
4.Replace the brush roller by inserting the brush
roller end into the right side of the holder, then
attach the roller tab to the left side to lock into
place.
Fig.D-12
5.Clean the the bristle after each use with the
cleaning tool.
Fig.D-13
Accessory Hose & 2 in 1 Nozzle
1.Press the buttons on both sides to remove the
hose.
Fig.D-14
2.Press the release button to remove the
accessory brush.
Fig.D-15
3.Remove the top cover and brush head.
Fig.D-16
4.Rinse with water. Allow it to dry completely
before reinstalling.
Fig.D-17
5.Reinstall.
Fig.D-18