22
Cable Installation
Please note that when installing cables to the rear of the X200 it is important not to arrange or clamp
them in such a way as to impede the free movement of the rear anti-vibration mounts.
Installation Procedure
It is advised that some form of thread-lock compound should be used on the screws securing the wire
rope mounts to both the X200 and mounting surface. This is in order to prevent loosening due to
vibration. WARNING -
Ensure only a small amount of adhesive is added to the screw points. Excessive
amounts will leak onto the circuit board and damage components.
Attach the Wire Rope Mounts to the X200 with four of the countersunk M4 hex-head screws provided
and L-shaped hex key. When attaching the rear pair of mounts please ensure that the stabilizer is
„sandwiched‟ between the mounts and the X200 by aligning the stabilizer holes with the mounting holes
in the X200.
Please note that the „open‟ end of the C-shaped plastic stabiliser should be attached to the rear wire
rope mounts and face backward.
Once all of the Wire Rope Mounts have been securely attached to the X200, use a pair of countersunk
M4 hex-head screws to atta
ch the bottom „feet‟ of the front Wire Rope Mounts to the mounting
surface/enclosure.
Secu
re the lower „feet‟ of the rear Wire Rope Mounts to the mounting surface/enclosure using the
remaining pair of countersunk M4 hex-head screws and a standard L-shaped hex key. Ensure that the
stabili
zer is „sandwiched‟ between the lower feet and the mounting surface/enclosure by screwing
through the Wire Rope Mount feet, then the stabilizer and into the mounting surface/enclosure.
Summary of Contents for X300 Series
Page 18: ...18 X300 DIGITAL RECORDER...