Timespace X300 Mark 2, Instruction Manual

Page: 141 / 185

X300 Instruction Manual Chapter 6 - Installation Guide
130
6.5 Installation Instructions
The X300 Mark 2 is supplied without any mounting kits. It can be used free-standing or it can be
mounted using the 4 x threaded holes on the underside - mounting screw size M4, 0.7 Pitch, 12mm).
Timespace can also supply 2 different
vehicle mounting system kits if required.
The X300-16M is supplied pre-mounted on the Timespace Vehicle Mounting Plate System. This can
then be screwed to the vehicle’s mounting surface as required.
The X300 requires 12V regulated power. This can be applied to either via 12V DC jack socket or 12V
screw terminals.
X300-16M only - the built-in GSensor must be configured during the installation process. Once the
X300 is installed, the direction of the front and side panel must be set in the GSensor setup menu e.g.
Front panel FORWARDS means the X300 front panel is facing the front of the vehicle, therefore the
Connector Panel must be either LEFT, RIGHT, UP or DOWN depending on the mounting position.
After configuring the X300 orientation, the GSensor readings must be zeroed using
ZERO THE
ACCELEROMETER in SYSTEM SETTINGS > GSENSOR > GSENSOR SETUP > ZERO THE ACCELEROMETER .
NB: the X300 (Mark 2) does not have a built-in GSensor. A separate unit can be fitted, contact
your supplier for further details.
NB: Do not use both power inputs simultaneously. Cameras and other external equipment should
be connected / wired to the X300 before power is applied.