X300 Instruction Manual
Chapter 6 - Installation Guide
134
6.5.3
Mounting Kits
The X300-16M comes pre-mounted on the Timespace Vehicle Mounting Plate System.
The X300 Mark 2 is delivered un-mounted. Timespace can provide 2 different kits for mounting the
X300 Mark 2 in mobile installations subject to shock and vibration. Please adhere to the following
instructions for the installation of the mounting kits, as failure to do so may result in the kits not
working correctly.
6.5.3.1
Timespace T408 Vehicle Mounting System
Quantity
Description
4
Wire Rope Mounts
1
Stabiliser Coupling
8
M4 x 12mm Counter-Sunk Hex-Head Screws
In addition you will require a standard ‘L’ shaped hex key. This is essential, as when all of the other
screws have been tightened, there is no room for any other tool to tighten the front lower pair of
screws.
Mounting Hole Preparation
Drill four mounting holes to attach the Wire Rope Mounts. If you intend to use the M4 x 12mm
screws into blind holes, then the holes will have to be drilled and tapped to accept an M4 screw, with
a thread depth of no less than 8mm.
If mounting the Wire Rope Mounts through a metal plate, then longer screws may have to be used in
order to allow a washer and nut to be attached on the other side of the plate. The length of these
screws will have to be chosen depending on the thickness of the plate and the height of the washer
and nut.
Please note that any screw used for mounting the wire rope mounts to an enclosure surface must
have an M4 thread and have a counter-sunk hex-head.
Figure 18 - Vehicle Mounting System - Mounting Hole Preparation
Summary of Contents for X300 Mark 2
